31
Note 1: At 80MHz and 800MHz, the separation distance for the higher frequency applies.
Note 2: These guidelines may not apply in all situations. Electromagnetic propagation is
affected by absorption and reflection from structures, objects and people.
Guidance and manufacturer’s declaration - electromagnetic emissions
The Body Clock Stimplus Pro is intended for use in the electromagnetic environment specified
below. The user of the equipment or system should ensure that it is used in such an environment.
Recommended separation distances between portable and mobile
RF communications equipment and the Body Clock Stimplus Pro
The Body Clock Stimplus Pro is intended for use in an electromagnetic environment in which
radiated RF disturbances are controlled. The user of the equipment or system can help prevent
electromagnetic interference by maintaining a minimum distance between portable and mobile
RF communications equipment (transmitters) and the Body Clock Stimplus Pro as recommended
below, according to the maximum output power of the communications equipment.
Rated maximum Separation distance according to frequency of transmitter (m)
output power of
transmitter (W) 150kHz to 80MHz 80MHz to 800MHz 800MHz to 2.5GHz
0.01 0.12 0.12 0.23
0.1 0.38 0.38 0.73
1 1.2 1.2 2.3
10 3.8 3.8 7.3
100 12 12 23
For transmitters rated at a maximum power output not listed above, the recommended
separation distance d in metres (m) can be estimated using the equation applicable to the
frequency of the transmitter, where P is the maximum output power rating of the transmitter in
watts (W) according to the transmitter manufacturer.
Test
Group 1
Class B
n/a
Compliance
The Body Clock Stimplus Pro uses RF energy only
for its internal function. Therefore its RF
emissions are very low and are not likely to cause
interference in nearby electronic equipment.
The Body Clock Stimplus Pro is suitable for use in
all establishments and those directly connected
to the public low-voltage power supply network
that supplies buildings used for domestic
purposes.
Emissions
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic
fluctuations/
IEC 61000-3-3
Voltage
fluctuations/
flicker emissions
IEC 61000-3-3
To Next Page
Loading...