8
STEP
1
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware in this step unless otherwise noted.
A. Slide Main Frame (A) into Pivoting Frame (B) and connect to Shaft (12) as
shown using:
Two 22 (M8x16mm hex head bolt)
Two 28 (M8, OD 24mm washer)
B. Secure the shaft assembly as shown using:
Two 18 (M8x10mm Set Screw)
C. Lock Pivoting Frame (B) to Main Frame (A) using Lock Pin (32) until the unit is
ready to use.
D. Secure Weight Horn Collar (53) to the Weight Horn.
To Next Page
Loading...
