BodyCraft HFT - STEP 4 Assemble Cable and Pulleys

P3
P4
P7
P6
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
STEP 4 Assemble Cable and Pulleys
8
P1
P9
P2
P3
P4P6
P8
P7
51
P2
P1
69
36
36
53
63
36
63
36
69
69
63
63
6R
36
53
69
15R
18
71
69
1R
53
36
Cable (27)
Ball End Bolt End
Bolt Holder
Simultaneously install Cables and Pulleys.
Jam
Nut 1/2
Jam
Nut 2/2
Fig. B
Fig. A
Fig. C
Fig. D
Fig. E
1. Feed the Bolt End of Cable (27) through Rotating Pulley Holder (17) Fig A. Route over
the two Pulleys P3 and P4 mounted on the Right Top Frame (6R) Fig B. Route down and
around the Pulley Block (18) Pulley P5 Fig C.
2. Route the cable up and over Pulleys P6 and P7 in Right Top Frame (6R) Fig B, then
down and around Pulley P8 on the Right Base Frame Leg (1R) Fig D. Then up to
threaded Bolt Holder welded onto the Right Pulley Height Adjuster (15R) Fig E.
NOTE: The Bolt must installed a minimum of 1/3 of the way into Bolt Holder.
3. REPEAT procedure for the Left side.
4. Tension Cables by adjusting bolts in Pulley Height Adjusters (15R,16L) Fig E. If you
still have slack, adjust Pulley Block (18) into Selector Rod (20) Fig C, and then re-adjust
Cable Bolt in Pulley Height Adjusters (15R,16L). TIGHTEN ALL Jam Nuts located at
Bolt Holder Fig E and Pulley Block (18) Fig C until bolts are unable to turn.