Slight
Angle
Fig. B
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
STEP 3 Assemble Guide Rods
7
56
48
41
1L
6L
19
20
5
5
21
22
23
24
22
23
24
56
64
60
64
60
14
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
1. Insert two Plastic Guide Rod Holders (24) into the outer holes of each of the Base Frame
Legs (1L & 1R). Insert two Guide Rods (5) into the Plastic Guide Rod Holders (24).
If you have 28 Weights Plates (21) (14/side), install the Stack Spacers (23) onto the guide
rods, (If you have 38 weight plates DISCARD Spacers). Install two Rubber Donuts (22).
2. Assemble Top Plate (19) to the Selector Rod (20) using the Top Plate Bolt (48), tighten
Thread Pulley Block (18) into Selector Rod (20) a minimum of 1/3 of the way (Fig. A).
3. TWO PEOPLE REQUIRED TO ASSEMBLE THIS STEP. With the guide rods angled slightly
(Fig. B), slide the Weight Plates (21) onto the Guide Rods (5) (NOTE: Orient the selector
holes toward the inside bottom. Slide the Top Plate (19) assembly onto the Guide Rods (5),
running the Selector Pin (41) down through the center holes of the Weight Plates (21).
4. Slide Top Guide Rod Holder (14) onto the Guide Rods (5) and secure to the top of the
Left Top Frame (6L), using the two pre-installed
Bottom Head Bolts (56) and 5/16"
Chromed Washers (64). Tighten the two pre-installed Set Screws (60) and
Bottom Head
Bolt
s (56).
5. Repeat steps for the other side.
Fig. A
20
18
48
DO NOT INSTALL
STACK SPACERS
(23) if you have 38
WEIGHT PLATES.
To Next Page
Loading...
