14
Step 4: Assembly of the Pedals
1. Screw the right pedal (1R) clockwise onto the right
crank arm (36).
2. Screw the left pedal (1R) counter-clockwise onto the
left crank arm (33).
Step 5: Alignment of the Feet
If the oor is uneven, you can stabilize the equipment by
turning the two setting screws under the main frame.
1. Lift the equipment on the desired side and rotate the
setting screws under the main frame.
2. Rotate the screws clockwise in order to remove them
and to raise the equipment.
3. Rotate them counterclockwise in order to lower the
equipment.
To Next Page
Loading...
