Assembly is complete! Please take the following steps before using the
BODYMAX B200 INDOOR TRAINING CYCLE:
1. Make certain all bolts are tightened securely.
2. Seat Post (15) and Handlebar Stem (20) are adjusted to your personal desired height
and locked with the Lock Lever (18). Note: You can pull the LockLever to position
the lever away from the frame if needed. Then release the lever and screw tight.
3. Wipe sweat away after every use. Failure to do so may result in a rusty bike.
4. Do not over tighten the V-Block fixed screws (19) . The depth is preset at the factory.
Over tightening can result in stripped threads.
5. Enjoy many years of a fit lifestyle!
10
PLEASE REGISTER YOUR WARRANTY CARD AT
www.bodymaxfitness.com
TEL: 0141 951 4477
To Next Page
Loading...
