Boeing 737NG
Digital Clock Replica
User’s Manual
• Read this manual and the Quick Reference
Handbook thoroughly before using the clock
• After reading this manual, keep it in a readily
accessible place for future reference
• Do not disassemble the clock by yourself.
Otherwise, you risk losing the one-year
warranty
•
To ensure flight safety, DO NOT switch this
clock on onboard any aircraft
• For your own safety and the safety of others,
use this clock responsibly
Warning
Warning sounds recorded from real cockpits are
used as alarms in this clock,
DO NOT bring this clock into any cockpit;
DO NOT turn this clock on onboard any aircraft.
Boeing 737NG Digital Clock Replica
Socket-USB Power Adaptor (Type A)
You will find in the package:
• 1:1 replica of the cockpit digital clock onboard
Boeing 737 NG aircraft, functions include time
& date display, UTC time & date display, photo-
sensor brightness adjustment, stopwatch and
en-route timer
• A wired speaker using 3.5mm AUX cables
• Alarm functions with 19 selected soundtracks
ranging from songs, announcement recordings
to real cockpit warning sounds
• Internal battery provides up to 24 hours of
unpowered display
1. Stopwatch key. Press once to start, twice to stop,
three times to reset the stopwatch to zero.
2. En-route timer key. Press once to start
(indicated by “RUN” displayed on the bottom
left corner), twice to hold (indicated by “HLD”).
On HLD, press to start the timer again.
3. Reset key. When the timer is on hold, press and
hold this key to reset the timer to zero.
4. Date and UTC time/date display key. Press once
for local date, twice for UTC time, three times
for UTC date. On the UTC date page, Press
again to return to local time.
5. Set time/date key. On time/date display pages,
press this key once to enter setting mode. You
will see the digits start to flash in setting mode.
Use key 6 and 7 to increase or decrease selected
digit values. Press key 5 again to change the
subject of the setting. To exit setting mode,
press key 5 until no digits are flashing. You
cannot change UTC time and date in the setting
mode.
6. Increase the selected value in setting mode.
7. Decrease the selected value in setting mode.
To Next Page
Need help?
General