11
Taxi, take-off and climbout
1. Request push back to the left by pressing SHIFT+P followed by 1. The
aircraft will begin pushback to the left. Once the aircraft has been pushed
back to the left and lined up, request a pushback cancel by pressing
SHIFT+P.
2. Deploy flaps to 5 and turn on the TAXI light. Set TCAS to TA/RA by going
to the centre pedestal and switching the TCAS switch until it is at the
desired setting. Arm the L (left) and R (right) A/T switches. All displays
should now be clear of any warnings or cautions.
3. Release the parking brake and slowly spool the engines forward to
maintain a taxi speed of 20KNOTS. Do not exceed 10KNOTS when turning.
Be carefully, the Boeing 777 is a very large and powerful aircraft!
4. Taxi to and hold short of runway 27R.
5. Once held short of runway 27R, arm the F/D (flight director). Press the
LNAV and VNAV buttons, which should glow green. Pink bars will now
appear on the PFD (primary flight display). Follow this guides after take-
off. Turn on the landing, strobe, logo, beacon and NAV lights. Set
autobrakes to RTO.
6. Taxi onto the runway.
To Next Page
Loading...
