Installation
Specification
Dimensions: Height 797mm Depth 435mm Width 377mm
Weight:
Voltage: 100-240V
Frequency: 50/60Hz
Full load current: 10.0A
Power: 1100ω
Capacity:300m
3
/h
Connection to Power Supply
Please follow the above specification when selecting the
power supply outlet for the AD Nano+ system, ensure the
power supply is suitable before connecting the AD Nano+
system.
Check the Integrity of the electrical power cable, if the
supply cord is damaged the extraction unit should not be
connected to the mains. The supply cord should only be
replaced by a BOFA engineer as an electrical safety test may
be required after replacement.
The AD Nano+ MUST be connected to a properly earthed
outlet.
If your AD Nano system was ordered with any optional
extras please read section 4.02 before the
power connection is made as additional
connections may be required before power is connected
to the extractor.
Connect the power cable to an isolated electrical supply.
The mains socket should be installed near the extractor it
should be easily accessible and able to be switched On/ Off.
The cable run should be arranged so as not to create a trip
hazard.
To Next Page
Loading...