W Series
© Böhmer-AG © Böhmer-AG
5
English
Assembly
Before Starting
The rubber feet are positioned on the two sub frames of the
generator unit. Locate the four pre-drilled holes. Thread the
bolts through the rubber feet and secure using the nuts.
The battery is connected
Black to ‘-’ negative, red to ‘+’
positive. Secure with nut and
bolt then shield with terminal
covers.
Add fuel:
1. Open the ller cap
2. Fill with unleaded petrol up to the lter
3. Replace ller cap
nhk
Fuel gauge / ller cap
Oil ller bung
Add oil:
Note: The generator will automatically shut down if
insufcient oil is detected.
1. Place generator on a level surface
2. Open the oil dipstick
3. Fill with 10W-40 semi-synthetic oil up to the threads
4. Replace oil dipstick
To Next Page
Loading...
