22
Additional settings
i
Installation of the memory control
Save and set preferred heights using the number keys.
First the table must be moved to the desired position.
Press key „S“ briey - the display starts to ash.
Press the desired number key (1, 2, 3 or 4).
This height position is now stored on the corresponding number key. Pressing the number
key adjusts the table to the stored height.
>> Saving favourite positions <<
Adjustment allows switching between metric (cm) and imperial (inch) on display.
1. Press and hold key „S“
2. Shortly after press „DOWN“ and hold
3. Keep both pressed for ca. 3 secs -> Display shows then in inches. To change back,
repeat process.
4. Setting completed
>> Changing unit of length <<
Function serves to limit the low point of desk - once set - cannot be moved below the set-
stop point.
Adjust the height to the position where the stop point should be set.
1. Press and hold the key „S“
2. Shortly after, press and hold key „1“
3. Hold both pressed for ca. 3 secs
The display conrms the setting
Attention ! Favourite positions below the stop are deleted.
>> Set Container Stop <<
To Next Page
Loading...