24
i
If the table encounters a solid obstacle during height adjustment, this is detected by the
sensor and the adjustment stops immediately.
Furthermore, the desk moves a little in the opposite direction.
Depending on the installation situation on site, it may be necessary
to adjust the sensitivity of collision sensor.
Press and hold the „S“ key for 6 seconds.
Release the „S“ key as soon as „- - -“ is displayed.
Press the key „3“.
The number in the display ashes.
(The standard setting is programmed for medium sensitivity - G-2)
Change or disable the sensitivity. Once you have made one of the settings below, wait
until the normal height display appears again. The setting is now complete and saved.
G - 0 = Disabled
G - 1 = Lowest setting
G - 2 = Average sensitivity
G - 3 = High sensitivity
G - 4 = Highest sensitivity
>> Setting the collision sensor <<
!
Any setting is lost with a reset and is reset to G-2 (see reset mode).
Additional settings
Installation of the collision sensor
To Next Page
Loading...