Bolens 11A-020W765 User Manual

WARNING: Read and understand all instruction,
warning, and danger labels.
Para instrucciones en Español, refiérase al Manual
del Operador.
Tools Required
• ⁄-inch wrench (or adjustable wrench)
• ⁄-inch wrench (or adjustable wrench)
• ⁄-inch wrench (or adjustable wrench)
• ⁄-inch wrench (or adjustable wrench)
• Flat-head screwdriver
Chute Deflector Assembly
NOTE: Use the hardware in Group 1 to complete the following
steps. Refer to your Operator’s Manual.
1. Align the holes on the chute deflector with the
corresponding holes on the deck surface.
2. Insert carriage screws up through the underside of the
deck and through the chute deflector. See Figure 3-1.
Figure 3-1
3. Secure each screw with a washer and lock nut.
Lower Handle Assembly
NOTE: Use the hardware in Groups 2 and 4 to complete the
following steps.
1. Lift the rear of the deck and place it on a block of wood to
secure it.
2. Place the lower handle over the deck and align the holes on
the deck with the corresponding holes on the handle.
3. Pivot the lower handle forward and secure it to the deck
using the hex screws, shoulder screws, and flange lock
nuts. See Figure 3-2.
Hex Screw
Shoulder
Screw
Figure 3-2
Upper Handle Assembly
NOTE: Use the hardware in Groups 2 and 4 to complete the
following steps. Refer to your Operator’s Manual.
1. Place the upper handle in position over the lower handle
keeping the blade control handle facing up.
2. Secure the upper handle to the lower handle using the
carriage bolts and lock nuts from Group 4 of the hardware
pack. See Figure 3-3.
Figure 3-3

Bolens 11A-020W765 Specifications

General

Engine Type	4-Cycle
Cutting Width	21 inches
Starter Type	Recoil
Drive Type	Manual
Weight	57 lb
Engine Displacement	140cc
Oil Capacity	15 oz
Fuel Capacity	1.5 quarts
Engine	Briggs & Stratton
Cutting Height	1.25 - 3.75 in

Summary

Chute Deflector Assembly

Chute Deflector Assembly

Use the hardware in Group 1 to complete the following steps. Refer to your Operator's Manual.

Upper Handle Assembly

Upper Handle Assembly

Use the hardware in Groups 2 and 4 to complete the following steps. Refer to your Operator's Manual.

Lower Handle Assembly

Lower Handle Assembly

Use the hardware in Groups 2 and 4 to complete the following steps.

Wheels

Wheels

Use the hardware in Group 3 to complete the following steps. Refer to your Operator's Manual.

Blade Control

Blade Control

If the blade control is secured and in place on the upper handle, you may skip the following three steps.

Control Cable (Snap Fitting)

Control Cable (Snap Fitting)

Unwrap the control cable from the engine and route it under the lower handle.

Z Fitting

To make it easier to attach the Z fitting, temporarily remove the left side of the blade control.

Control Cable (Stud)

Securing Control Cable

WARNING: The cable must be routed properly to avoid contact with sharp edges and hot surfaces.

Z Fitting

To make it easier to attach the Z fitting, temporarily remove the left side of the blade control.

Starter Rope

Starter Rope

Use the hardware in Group 5 and refer to Figure 3-10 to complete the following steps.

Gas and Oil Fill-Up

Gas and Oil Fill-Up

Refer to the separate engine owner's manual for additional engine information.