How to troubleshoot Bolens Trimmer engine that will not start?
If your Bolens Trimmer engine won't start, there are several potential causes. First, ensure the On/Off control is set to ON. If it is, check the fuel tank and fill it with fresh fuel if empty or old. Also, make sure you press the primer bulb fully and slowly 10 times. A fouled spark plug or a plugged spark arrestor could also be the culprit; try cleaning or replacing them.
Why does my Bolens BL26C0, BL26SS, BL26BC engine lack power or stall?
If your Bolens Trimmer engine lacks power or stalls, the issue might be due to old fuel. In this case, drain the gas tank and add fresh fuel. Alternatively, the carburetor may need adjustment, which should be done by an authorized service dealer. A fouled spark plug or a plugged spark arrestor could also cause this; try cleaning or replacing them.
Why is cutting line advancing uncontrollably on my Bolens Trimmer?
If the cutting line on your Bolens Trimmer advances uncontrollably, it is likely due to oil, cleaner, or lubricant in the cutting head. Clean and thoroughly dry the cutting head to resolve this issue.
What to do if Bolens BL26C0, BL26SS, BL26BC engine will not accelerate?
If your Bolens Trimmer engine won't accelerate, consider these possibilities: old fuel (drain and replace), a dirty air filter (clean or replace), or a plugged spark arrestor (clean or replace). Also, the cutting attachment might be bound with grass, in which case you should stop the engine and clean the attachment. If these steps don't resolve the issue, the carburetor may need adjustment by an authorized service dealer.
How to fix Bolens BL26C0, BL26SS, BL26BC engine that will not idle?
If your Bolens Trimmer engine won't idle, it might be due to a plugged air filter, which you should clean or replace. Old fuel can also cause this issue, so drain the gas tank and add fresh fuel. If neither of those solutions works, the carburetor may need adjustment.
What to do if cutting attachment will not advance on Bolens Trimmer?
If the cutting attachment on your Bolens Trimmer won't advance, first stop the engine and clean the cutting attachment if it's bound with grass. Other potential causes include the cutting attachment being out of line (refill with new line), an inner reel bound up (replace the inner reel), a dirty cutting head (clean inner reel and outer spool), line welded (disassemble, remove the welded section and rewind), line twisted when refilled (disassemble and rewind the line), or not enough line exposed (push the bump knob and pull out line until 4 inches (102 mm) of line is outside of the cutting attachment).
Covers safe fueling procedures, operation in ventilated areas, and protective gear.
Provides critical safety rules to follow before and during operation.
Details safety precautions unique to operating the BL26BC with a cutting blade.
Details safety precautions for gasoline-powered units regarding flammability.
Guides for installing harness, shield, and cutting blade for BL26BC.
Detailed steps for safely installing the cutting blade, including torque specifications.
Step-by-step guide for safely fueling, including additive use and blended fuel precautions.
Details the steps required to start the trimmer engine, including choke and primer use.
Explains how to properly shut down and stop the trimmer engine.
Guides on holding, adjusting line, and tips for effective trimming.
Procedure for checking the oil level.
Instructions for changing oil and maintaining the air filter.
General| Engine Type | 2-Cycle |
|---|---|
| Cutting Width | 16 inches |
| Line Diameter | 0.095 inches |
| Cutting System | Dual Line |
| Shaft Type | Straight |
| Starting System | Recoil |
To Next Page
