Bolt Power N02 - Understanding Error Conditions

-5-
Understanding Error Conditions
The N02 shall display and error condition when you reverse polarity condition is
present, a battery below two (2) volts, or internal battery overheating. When one
of these error conditions are present, the following will happen
Error Reason/Solution
Reverse polarity/
Reverse the battery
Connections
Error LED
Solid Red
Boost LED
Boost Button DC Output
Error LED
Blinking Red
w/cables connected
Properly
Boost Light does
not come on
w/cables connected
properly
The internal battery
is too hot/bring the unit
into cooler enviroment
Connected battery is below
2-volts/ remove all loads,
and try again, or use
manual override mode