20
CAUTION
CAUTIONCAUTION
CAUTION:
::
:
In case of disconnection or power failure:
- Wait for approx. 5 minutes before restarting.
- Check the operation settings.
• Ensure that your mains power corresponds with
the specifications of the appliance. The specifica-
tions are printed on the rating label.
• Connect the mains cable to a properly installed
and earthed wall outlet.
• If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Reverse the
Reverse the Reverse the
Reverse the door o
door odoor o
door opening
peningpening
pening
If required, the door openings can be moved from the
right (supplied condition) to the left side.
WARNING:
WARNING:WARNING:
WARNING:
When replacing the door stops, the appliance must
be disconnected from the power supply. Always un-
plug the appliance first.
NOTE
NOTENOTE
NOTE:
::
:
• When installing, ask another person to assist.
•
You possibly need:
screw wrench, Phillips screw-
driver as well as a thin-blade screwdriver.
From right to left side From left to right side
• First dismount the stop plate (A).
• Dismount the upper door hinge (2) by loosening
the screws (1). Open the freezer door a little and
take it carefully of the middle door hinge. Place
the door safely aside.
• Solve the middle door hinge (4) with the screws
(3). Open the fridge door a little and take it care-
fully of the lower door hinge. Place the door at a
safe place too.
• Tilt the appliance slightly backwards and block it
in this position. Dismount the lower door hinge (6)
and the door support device (7).
• Attach the door hinge (6) and the door support
device (7) each on the other appliance side, after
you have displaced the hinge pin (5) in the hinge
(6) accordingly.
• Replace the appliance upright again. Put on the
fridge door and fix it to the property position.
• Turn the middle door hinge (4) about 180° and
transfer it at the opposite side. Put the hinge pin
in the hole of the fridge door and tight the screws
(3).
• Put on the freezer door and fix it to the property
position.
• Transfer the upper door hinge (2) on the opposite
appliance side. Put the hinge pin in the hole of the
freezer door and tight the screws (1).
• Check if the doors are arranged vertically as well
as horizontally, so that a smooth opening and
closing of the doors are ensured.
• Install the stop plate (A).
Built
BuiltBuilt
Built-
--
-in
inin
in
Built-in openings
Height x Width x
Depth
1450 x 560-570 x
550 mm
Figures in mm
For the appropriate venting an exhaust duct of
approx. 50 mm depth is to provide at the appliance
back.
To Next Page
Loading...
