BOMANN EHC 3553 - Page 8

Any unnecessary accessories should be removed
from the baking chamber before using the appliance.
During cooking, the oven door should remain closed
to avoid unnecessary heat loss.
Only preheat the oven if required by the recipe.
If a selection of cooking time is specified, always use
the lowest recommended temperature.
Use the residual heat by switching back to minimum
temperature shortly before the end of the cooking
time.
Sa
ve electricity! If you do not need the oven, switch
off functions such as interior lighting, program, te
perature
Clean the oven after each application, to keep the
cleaning effort as low as possible.
We recommend the use of biological cleaners.
Informati
InformatiInformati
Informati
on to professional users for disassembly
on to professional users for disassembly on to professional users for disassembly
on to professional users for disassembly
(acc. VO (EU) No. 66/2014 appendix I, No. 2)
(acc. VO (EU) No. 66/2014 appendix I, No. 2)(acc. VO (EU) No. 66/2014 appendix I, No. 2)
(acc. VO (EU) No. 66/2014 appendix I, No. 2)
Oven
OvenOven
Oven
Information for non-
destructive disassembly for
maintenance purpose
Remove the lamp as described in the manual.
For maintenance purposes, the oven door can be
hang out and reinstalled, for the procedure please
refer to the manual.
A further disassembly for maintenance purposes is
not provided.
If you would like to exchange defective components,
please contact our customer service.
Accumulators are not included.
Information for disassembly in terms of recycling,
recovery and disposal at the end of the life of the
appliance
The disassembly of appliances with a gas connection
should only be carried out by a licensed gas and
water installer.
8
Any unnecessary accessories should be removed
from the baking chamber before using the appliance.
During cooking, the oven door should remain closed
Only preheat the oven if required by the recipe.
If a selection of cooking time is specified, always use
the lowest recommended temperature.
Use the residual heat by switching back to minimum
temperature shortly before the end of the cooking
ve electricity! If you do not need the oven, switch
off functions such as interior lighting, program, te
m-
Clean the oven after each application, to keep the
We recommend the use of biological cleaners.
on to professional users for disassembly
on to professional users for disassembly on to professional users for disassembly
on to professional users for disassembly
(acc. VO (EU) No. 66/2014 appendix I, No. 2)
(acc. VO (EU) No. 66/2014 appendix I, No. 2)(acc. VO (EU) No. 66/2014 appendix I, No. 2)
(acc. VO (EU) No. 66/2014 appendix I, No. 2)
destructive disassembly for
Remove the lamp as described in the manual.
For maintenance purposes, the oven door can be
hang out and reinstalled, for the procedure please
A further disassembly for maintenance purposes is
If you would like to exchange defective components,
please contact our customer service.
Information for disassembly in terms of recycling,
recovery and disposal at the end of the life of the
The disassembly of appliances with a gas connection
should only be carried out by a licensed gas and
The disassembly of appl
iances with electrical co
nections should be carried out by a licensed electr
cian.
For the recycling and recovery of resources give the
appliance to:
-
a communal collection point of public waste dispo
al authorities
-
a dedicated disposal company, offer
system
-
a resident electric trader, who voluntary withdraws
electrical appliances
Before initial use
Before initial useBefore initial use
Before initial use
•
Clean the oven interior with all therein located
accessories. Follow the instructions that we give
you in the chapter "Cleaning and
•
In order to burn any manufacturing residue, h
the closed oven for approx. 70 minutes at 200°C.
U
se the heating function [
switch to the heating function [Grill] for an
20 minutes.
NOTE
NOTENOTE
NOTE:
: :
:
The occurring odor
and possibly a slight smoke
development cannot be avoided. Therefore e
sure for a good ventilation of the room during
heating.
Operation
OperationOperation
Operation
1
11
1
Level regulator of cooking zones
Level regulator of cooking zonesLevel regulator of cooking zones
Level regulator of cooking zones
The temperature setting is
set for each cooking zone
separately by using the
respective level regulator.
CAUTION:
CAUTION:CAUTION:
CAUTION:
Depending on model!
Depending on model!Depending on model!
Depending on model!
Turn the
level regulator of the double cooking and
roasting tin zone
only clockwise and back again.
Otherwise the regulator
will be damaged.
iances with electrical co
n-
nections should be carried out by a licensed electr
i-
For the recycling and recovery of resources give the
a communal collection point of public waste dispo
s-
a dedicated disposal company, offer
ing a return
a resident electric trader, who voluntary withdraws
Clean the oven interior with all therein located
accessories. Follow the instructions that we give
you in the chapter "Cleaning and
Maintenance".
In order to burn any manufacturing residue, h
eat
the closed oven for approx. 70 minutes at 200°C.
se the heating function [
Upper/lower heat]. Then
switch to the heating function [Grill] for an
other
and possibly a slight smoke
development cannot be avoided. Therefore e
n-
sure for a good ventilation of the room during
Level regulator of cooking zones
Level regulator of cooking zonesLevel regulator of cooking zones
Level regulator of cooking zones
set for each cooking zone
respective level regulator.
Depending on model!
Depending on model!Depending on model!
Depending on model!
level regulator of the double cooking and
only clockwise and back again.
will be damaged.