24
• Remove the cable cover strip on the top of the
door and the dummy cap (a).
• Loosen the hinge cover and disconnect the plug
connections.
• Remove the door contact switch from the hinge
cover and fit it into the enclosed hinge cover.
• Disassemble the upper door hinge and lift out the
appliance door.
• Remove the door stopper on the bottom of the
door and install the enclosed door stopper on the
other bottom of the door. Place the door safely
aside.
• Tilt the appliance back slightly and block it in this
position. Unscrew the feet and disassemble the
lower door hinge.
• Transfer and attach the lower door hinge to the
opposite side of the appliance; after unscrewing
the hinge pin and inserting it into the adjacent
hole. Screw in the feet accordingly.
• Place the appliance back in the upright position.
Loosen the screw cover on the top of the appli-
ance and replace it on the other side.
• Put on the door of the appliance and fix it in the
intended position.
• Check the rubber door seal for proper fit and ad-
just it to the correct position if necessary.
• Move the cable on the appliance from the right to
the left slot.
• Transfer and attach the upper door hinge to the
opposite side of the appliance; after unscrewing
the hinge pin and inserting it from the other hinge
side.
• Route the connection cable through the hinge
opening. Put on the hinge cover, connect the dis-
play and door connectors, and screw the hinge
cover tight.
• Turn the blind cap (a) 180° and insert it.
• Remove the door handle (if it is already installed)
and attach it to the corresponding other side of
the door. Observe the instructions under
"Assem-
To Next Page
