BOMANN VSE7804 - Cleaning and Maintenance

22
Type
TypeType
Type o
oo
of sou
f souf sou
f sound
ndnd
nd Cau
CauCau
Cause
sese
se
Disturbing
noises
Vibration of the shelves or cool-
ing coils
Switching
SwitchingSwitching
Switching off
offoff
off
To swi
To swiTo swi
To swit
tt
tc
cc
ch off the appliance turn the temperature co
h off the appliance turn the temperature coh off the appliance turn the temperature co
h off the appliance turn the temperature con-
n-n-
n-
trol to
trol to trol to
trol to the off state.
the off state.the off state.
the off state.
If the appliance is out of use for long periods:
• Remove the appliance content.
• Disconnect the appliance from the power supply.
• Defrost (model dependent) and clean the device
thoroughly (see ”Cleaning and Maintenance”).
• Leave open the appliance door to avoid formation
of mold and unpleased odors.
Tips
TipsTips
Tips for Energy
for Energy for Energy
for Energy saving
savingsaving
saving
• Disconnect the appliance from the power supply,
if it isn’t in use.
• Do not install the appliance near stoves, heaters
or other heat sources. In case of higher ambient
temperatures, the compressor will run more fre-
quently and longer.
• Ensure enough ventilation at the bottom and rear
side. Never block ventilation openings.
• Adjust the temperature not colder than necessary.
• Allow warm food to cool before placing it in the
appliance.
• Open the unit door only as necessary.
• Defrost the unit regularly (model dependent).
• The seal of the appliance door must be complete-
ly intact, so that the door closes properly.
Cleaning and
Cleaning andCleaning and
Cleaning and Maint
MaintMaint
Maintenance
enanceenance
enance
WARNING:
WARNING:WARNING:
WARNING:
• Always disconnect the appliance from the power
supply before cleaning and user maintenance.
• Do not use steam cleaners for cleaning the appli-
ance; moisture could enter electrical components.
Risk of
Risk ofRisk of
Risk of el
elel
electric shock!
ectric shock!ectric shock!
ectric shock! Hot steam could damage
the plastic parts.
• The unit must be dry before restarting operation.
CAUTION:
CAUTION:CAUTION:
CAUTION:
• Do not use a wire brush or other sharp, abrasive
items.
• Do not use any acidic or abrasive detergents.
• Do not damage the refrigerant circuit.
Cleaning the appliance inc
Cleaning the appliance incCleaning the appliance inc
Cleaning the appliance including
ludingluding
luding inter
interinter
interi
ii
io
oo
or
rr
r
• Clean the appliance interior, the exterior surfaces,
the accessories and the door seal regularly with
warm water and mild detergent; or with a clean,
damp microfiber cloth without cleaning agent.
• Remove the appliance content and storage it at a
cool location.
• Clean the thaw water discharge channel / opening
carefully e.g. with a pipe cleaner.
• After everything was thoroughly dried, you can
restart the operation.
De
DeDe
Defrosting
frostingfrosting
frosting
CAUTION
CAUTIONCAUTION
CAUTION:
::
:
Never use metal objects (e.g. knifes) to remove ice
from the evaporator. Otherwise it can be damaged.
The appliance has an automatic defrosting system.
During defrosting water drops drains off at the back
of the cooling chamber. The thaw water running
through a channel, is collected in a drip tray located
on the compressor, where it will evaporate. Make
sure the water discharge opening does not get
clogged. A light formation of ice on the interior back
during operation is normal.