10
Program Drying level Program selection information
Loading
kg
Time
H/Min.
Energy
kWh
Sport ---
Sportswear, thin and light fabrics, micro-
fiber, polyester.
8 3:20 2.2
Mix ---
Blended fabric made of cotton and syn-
thetic fibers.
3.5 1:30 1.2
Wolle
(Wool)
---
For machine and dryer suitable wool
products.
1.0 0:08 0.06
---
Seide
(Silk)
---
For laundry such as lingerie (silk), which
must be treated gently.
1.0 0:45 0.35
Zeit
(Time)
---
For drying textiles in a user-defined time,
e.g. for after-drying of multi-layered tex-
tiles.
Drying regardless of loading and
moisture at predefined duration.
*Standard program: Cotton Standard
When fully loaded and partially loaded, this drying program is used to determine the information on the energy
label. This program is suitable for drying normal wet cotton textiles and most efficient in terms of cotton energy
consumption.
Automatic drying programs
The appliance detects the moisture of the load and
adjusts the optimal drying time automatically. The
electronic control guarantees the best drying results
even with low loading of the dryer.
It is enabled for all programs, except for the pro-
grams with time control.
Capacity
Do not overload the appliance, otherwise the textiles
will be damaged and drying will be impaired. Ob-
serve the information in the "Program table".
Drum light
As soon as you open the appliance door, the interior
of the drum is illuminated so that no laundry is forgot-
ten when removing it. The light is switched on for
about one minute each time.
Starting the program
NOTE:
Humming sounds at the beginning of a drying pro-
cess, which are generated by the compressor start-
up, are normal.
Connect the appliance to the power supply and
switch it on.
Put your laundry in the drum.
Close the appliance door properly.
Set the required operating conditions.
Start the drying program.
Changing the program
A change is not possible after the program has been
started. To select a new program, you must switch
the appliance off and on again.
End of program
At the end of the drying process, several beeps (sig-
nal activated) will sound, the corresponding control
lamp illuminate and the display shows [
0:00
].
To Next Page
Loading...
