Bompani BOLS12S - Unloading the Dishwasher

It is dan gero us to ope n the do or w hen w as hi ng , bec ause the hot wate r ma y s cald y ou.
When the wo rking cycle h as finished, the b uzzer of the dishwasher will soun d fo r 8 seconds, then st op. Turn o ff
the appliance using the ON/OFF button, shut off the water supply and open the door of the dishwasher.
Wai t f or a f e w m i n ut e s b e fore u n load i n g the dishw a sher t o av oid handl ing t he d i s he s a n d u t e ns i l s w h i le t hey
are still hot and more susceptible to breakage. They will also dry better.
Switch Off the Dishwasher
In the digital display appears total programme time but is n ot blinkin g, onl y in this case the programme h as ended.
1.S wit ch off t he di shwa sher by p ressin g t he O N/OF F b utto n.
2.Tur n o ff the w at er ta p!
Open the door carefully.
Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down around 15 minutes
bef ore rem ovi ng f ro m t he app lian ce.
Open t he dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. In this way they
will be cooler and the drying will be improved.
Unloading the dishwasher
It is normal that the dishwasher is wet inside.
Emp ty th e l ow er ba ske t f irst a nd the n t he up pe r o n e. T hi s w ill av oi d wat er dr ipp ing f rom t he upp er Bas k et o nto
the dishes in the lower one.
If you open the door , t he machine will pause. The LE D Display
Window will stop blinkin g and the buzzer w ill m oo ing every minute unless you close
the door . A fter you close the door ,the mac hine will keep on working after 10 seconds.
dur ing a wash cycle
Premise:
1Acyclethatisunderwaycanonlybemodifiedifithasonlybeenrunningforashorttime.Otherwise,the
detergent may have already been released, a nd the appliance may have already drained the wash water.
If t his is the case, the detergent dispenser must be refilled (see the section entitled " Loading the
Detergent " ).
2PresstheStart/Pausebutton,thenpresstheprogrambutton ,themachinewillbe
in standby state, then you can change the program to the desired cycle setting (see the section entitled
"Startingawashcycle...").
NOTE: During delaying state, press the Start/Pause button, then you can change the program and delay time.
3
mo re t ha n 3 s eco n ds
The LE D dis play shows the s tate of the dishw asher:
a) The LED shows ----------------------------------------------- stand by
b) The LED shows H MM and not blinking-------------------Being paused
c) The LED shows H M M and blinking -- ----------------------------Running
)..
 
 
Aforgottendishcanbeaddedanytimebeforethedetergentcupopens.
Add f orgotten dishes.
Close the door
After the spray arms stop working, you can open the door
completely.
2
3
Open the door a little to stop the w ash ing.
1
4
5
6
Press the Start/Pause button
Press the Start/Pause b utton, the dishwasher will run
after 10 seconds.
When you press the S tart/Pause button to pause during wa shing, the
will stop blinking and the d ishwasher will mooing every m inute unless you
press the Start/Pause button to start.
LED Display
Window