Bompani BOLS12S - Water Connection Procedures; Connecting the Safety Supply Hose; Disconnecting the Safety Supply Hose; Cold Water Connection Details

23
The following things sh ould be checked bef ore starting the dishwa sher.
The content of this manual is very helpful to the users.
After instal lation, pl ease m ake s ur e to keep this man ual.
1 The dishwasher is level and fixed properly
2
The inlet valve is open
3 There is a leakage at the connections of the conducts
4
The wires are tightly connected
5 The power is switched on
6
The inlet and drain hoses are knotted
7
All packing materials and printings should be taken out from the dishwasher
A hose that attaches to a sink spray can burs t if it is installed on the same water line as the d ishwasher. If your sink has one, it is
recommended thet the hose be disconnected and the h ole plug ged.
Pull The safety supply hoses completely out from storage compartment located at rear of dishwasher .
Turn water fully on before starting the dishwasher.
1
Tighter the screws of the safety supply hose to the faucet with thread 3/4inch.
The safety supply hose consists of the double walls. The hose's system guarantees its intervention b y blockin g the flow of water
in case of the supply hose breaking and when the air space between the supply hose itself and the outer corrugated hose is full
of water.
Turn off the water.
Release the water pressure by depressing the pre ssure release button. This relieves water pressure and protects you, and
the room, from severe splashi ng.
Unscrew The safety supply hose from the faucet..
3
2
1
2
3
The appliance must be connected to the water mains using n ew hose-sets.
The old hose-sets should not be reused.
Water pressure must be between 0,04 MPa and 1 MPa. If the pressure is below the minimum
consult our Service Department for advice.
Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure that it is fastened tightly in place.
If the water pipes are new or ha ve not been us ed fo r an extended period of time, let the water run t o make sure that the
water is clear and free of impurities. If this precaution is not taken, there is a risk that the water inlet can get blocked and
damage the applianc e.