CARE AND CLEANINGß
2.2. Maintenance
Disconnect the appliance from the electrical mains by disarming the fuses before carry-•
ing out any cleaning or servicing operations.
In the event of failure, please fi rst of all check the fuses of the household electricity sup-•
ply system.
If the problems are not caused by the power supply, kindly contact your Authorised Serv-•
ice Centre or the Bompani after-sales service, stating the model of the appliance and the
serial number stated on the nameplate.
To ensure that the appliance’s safety characteristics are not impaired, all maintenance •
work must be carried out by authorised personnel.
Improper maintenance work will result in forfeiture of warranty rights.•
Changing the oven light bulb
To replace the oven light bulb, follow the instructions provided below:
Switch the oven off and disconnect it from the power supply. The bulb is in the 1.
top right-hand corner of back wall of the oven;
Make sure that the oven is cold and unscrew the glass cover;2.
Unscrew the light bulb and replace it with another of the same type;3.
Screw the glass cover fi rmly back into place.4.
Removing the oven door
This procedure must only be carried out by qualifi ed staff, since it may involve safety risks
for the user.
The door can be removed by proceeding as follows:
Fully open the door;1.
Insert two small coins (e.g. 10 Eurocents) into the two slots in the hinges, and close 2.
the door until the coins have been pushed almost fully home (Fig.8). Handle the
door and hinges with great care while the coins are inserted.
Lift the door off, holding it at the sides and moving it slightly forward.3.
To put the door back in place, return the hinges to their positions, checking that 4.
they have fi tted into their seats; lower the door completely and remove the coins
inserted earlier.
Close the door again to the fully closed position.5.
fi g.8
Changing the Oven Door Gasket
Always inspect the oven door gasket and order a replacement from the after-sales service
without delay if worn.
19
To Next Page
Loading...
