EasyManua.ls Logo

Boneco 7144 - Troubleshooting

Boneco 7144
52 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
16
en
Storing the appliance for extended periods
Clean the appliance as described earlier and allow to dry
thoroughly. Preferably store the appliance in its original box,
in a dry place away from high temperatures.
Legal notice
The humidifier is cUL-listed.
Subject to technical change. The instructions for use are
protected by copyright © BONECO AG.
Accessories
Contact your local retailer or check our website
www.boneco.us for re-order information.
Customer Service
Customer Service (USA) 1-800-336-0326
www.boneco.us
Technical data
Electrical voltage 120 V / 60 Hz
Power consumption up to 45 W / (125W*)
Humidity output up to 3.5 gallons / 24 h*
Suitable for rooms up to 650 sq ft / 60 m
2
Dimensions (LxWxH) 10 x 11.4 x 13.7 in
25.4 x 29 x 34.7 cm
Weight (empty) 8.8 lbs / 4 kg
Accessories Demineralization cartridge A7531
Hydro Cell A200
EZCal A7417
EZCal PRO A100
* when used with pre-heating to 176 °F (80 °C)
Troubleshooting
Problem Possible cause What to do
Unit does not operate Power cable not plugged in Plug in power cable
No water in the tank (Empty-light red) Fill tank with water and wait 10 min.
No mist output Unit needs cleaning Descale the water base using EZCal and EZCal PRO
DMC exhausted Replace cartridge or granules
DMC overfilled with granules Take out 2 tablespoons of granules and throw
them away
Weak mist output Water temperature too low Set mist output to maximum, after 15 min.
the humidifier will work properly again
Mineral deposits on membrane Clean membrane using EZCal and EZCal PRO and brush
Unit running intermittently Replace demineralization cartridge or granules
White dust around the humidifier Demineralization cartridge exhausted Used granules must go in waste

Related product manuals