99
WARNING:
- The Ground Coffee Holder/Capsule Holder is hot after using the
appliance. Allow to cool before removing.
- Hot steam might be trapped under the Lid.
4. Once the brewing cycle has finished, all indicator lights switch off automatically.
Disconnect the Power Cord With Plug from the wall outlet.
5. Remove the cup/mug from the Cup Holder.
6. Allow the appliance to cool down before removing the Ground Coffee Holder/Capsule
Holder from the Insert Holder. Always remove any used coffee grounds/capsules after
use. Remove with caution as recently used coffee grounds or capsules can be hot.
resume brewing.
- Do not remove the cup/mug until all indicator lights have switched off.
NOTE:
- If you want to brew another cup/mug of coffee, allow the appliance to
cool for at least 1 minute, before starting a new brewing cycle. Always
ensure the water level is suitable for your next brew. Refill the Water
Reservoir With Lid if necessary. Always fill the Ground Coffee Holder with
fresh ground coffee or place a new capsule in the Capsule Holder. Do not
reuse the same capsule/ground coffee. Insert the Ground Coffee Holder
/ Capsule Holder in the Insert Holder and close the Lid afterward.
Repeat previous steps (Brewing).
1. Plug base into the socket before use. Once the milk frother plug in the base, the
indicator lights of 4 modes will flash once and then off.
2. Short press the button to choose the mode you want. The indicator light will move as
each time you press the button. Once you finish choosing mode and no operation for
3 seconds, the milk frother will run the mode you chose automatically.
3. The milk frother will stop automatically after working finished. You can also press the
button to stop it if necessary.
PREPARATION-MILK FROTHER
To Next Page
Loading...
