P
r
i
o
r to
any
f
a
u
l
t
f
i
nd
i
ng,
p
l
ea
s
e
ensure
a
ll
conn
e
c
t
i
on
s
to
the
ch
ill
e
r
are sound and t
h
a
t t
h
e
i
nco
m
i
ng
s
upp
ly
i
s
turned
on.
A
l
s
o,
ensure t
h
a
t
a
ll
e
l
e
ct
r
i
cal
l
conn
e
c
t
i
on
s
to
the
ch
ill
e
r
and
i
n
the
ch
ill
e
r
are secure and
i
n
good
cond
i
t
i
on,
the power
i
s
on
and that the ch
ill
e
r
has had
a
d
e
qu
a
t
e
t
i
m
e
to
reach
op
e
r
a
t
i
ng
t
e
m
p
e
r
a
t
u
r
e
.
NOTE:
I
s
o
l
a
t
e
from
m
a
i
n
s
before removing any
p
a
n
e
l
s
Check connections to water supply.
Check water supply is turned on.
Check water supply is turned on.
Check system for blockages.
Check system for blockages.
Check thermostat/temperature probe is correctly
located into the bath probe well.
Check the agitator is running. If supply voltage is
present renew agitator assembly.
If agitator is running with no water agitation check
agitation blades.
Insufficient air flow through the
fridge.
Check that the condenser is not blocked.
Check for blockages and obstructions to
ventilation grills.
Check supply to cooling fans.
If supply present replace fans.
If supply not present check connections,
thermostat, high side protection (digital thermostat
only) and fuse.
Check supply to Compressor.
If supply present return for repair.
If supply not present check connections,
thermostat, high side protection (digital thermostat
only) and fuse.
If compressor & fan are running and there is no
cooling, return for repair.
8
Eliwell
Wiring
S
c
h
e
m
a
t
i
c
To Next Page
Loading...
