BORLA 11853 User Manual

TITLE: Honda Accord Rear-Section Instal-
lation Instructions
Installation for Honda Accord
PN 11840, 11853
Thank you for purchasing a Borla Performance Exhaust System.
Borla Performance Rear Section Exhaust System (11840) is designed for the Honda Accord Sedan,
3.5L 6-cylinder engine FWD/automatic transmission and Sport Model with 2.4L 4-cylinder engine
FWD/automatic transmission. Does Not fit 2.4L 4-cyclinder engine with single exit.
Borla Performance Rear Section Exhaust System (11853) is designed for the Honda Accord Coupe,
3.5L 6-cylinder engine FWD, automatic/manual transmissions.
Borla Performance Industries recommends that an exhaust shop or professional after market parts installer perform the installation
of this system. However, if you decide to perform the installation on your own it is recommended that two people are used. This
installation should not be performed by one person due to the risk of injury. Ensure the installers use all under car safety precau-
tions including eye protection.
Please take time to read and understand the following…
By installing your Borla Performance Exhaust System, you indicate that you have read this document and you agree with the terms
stated below.
It is the responsibility of the purchaser to follow all installation instruction guidelines and safety procedures supplied with your
Borla Performance Exhaust System
Borla Performance Industries assumes no responsibility for damages occurring from misuse, abuse, improper installation, improp-
er operation, lack of responsible care, or all previously stated reasons resulting from incompatibility with other manufacturer’s
products and/or systems.
Included with your Borla Performance Exhaust System is a warranty card. Please read it carefully before you begin any work on
your vehicle. If you should have any questions regarding our warranty policy, installation, or any other matter pertaining to your
These instructions have been written to help you with the installation of your Borla Performance Exhaust System. Please
read this document completely before beginning the installation of your system.
Please compare the parts in the box with the bill of materials provided to assure that you have all the parts necessary for
this installation.

BORLA 11853 Specifications

General

Brand	BORLA
Model	11853
Category	Automobile Accessories
Language	English

Summary

Honda Accord Exhaust System Installation

System Compatibility and Overview

Details compatibility for Sedan (11840) and Coupe (11853) models, including engine and transmission types.

Installation Safety and Recommendations

Advises professional installation, two-person job, and safety precautions like eye protection.

Purchaser Agreement and Warranty

Outlines purchaser responsibility, liability disclaimer, and warranty card information.

Required Tools and Parts

Minimum Required Tool List

Lists essential tools including ratchet, extension, deep well sockets, and pry bar for installation.

Shop Supplies

Lists necessary shop supplies, specifically spray lubricant.

Bill of Materials

Details the parts included for both system numbers (11840 and 11853), listing muffler assemblies and clamps.

Original Exhaust System Removal

Preparation and Lubrication

Suggests applying penetrating spray lubricant to fasteners and hangers before disassembly.

Component Removal Steps

Details removing muffler flange hardware, rubber isolators, rear muffler assembly, and factory sealing ring.

Installation Warning

Warns against using air impact tools, emphasizing proper torque to prevent leaks.

New Exhaust System Installation

Muffler Assembly Placement

Instructs to place the muffler assembly into position using the factory gasket.

Hanger Installation

Details inserting muffler assembly hangers into factory rubber isolators and lightly tightening hardware.

Clamp and Inlet Fitment

Describes placing the clamp on the inlet and inserting hangers into rubber isolators.

Final Tightening and Checks

Covers checking clearance, tip alignment, tightening flange bolts and clamps, and leak checks.