BorMann Pro BAP7000 - Troubleshooting and Cleanup; Cleaning the Inlet Filter; Cleanup for Latex Materials; Important Cleaning Notes

EN
WWW.BORMANNTOOLS.COM
11
2. Using a garden hose, rinse o the sucon
tube, return tube and inlet lter. Empty the
waste container.
Empty waste container
3. Remove the inlet lter from the sucon
tube and place into a waste container (do
not discard).
1. Lock the gun and remove the spray p
assembly. Place the sucon tube and re-
turn tube into an empty waste container.
Verify that the seals arepresent inside the
adapter and sucon tube. Thread the pump
cleaning adapteronto a garden hose . Connect
hose and adapter to the ng on the end of
the sucon tube.
Connued on next page.
Spray gun - 1
Spray gun - 2
Tapered
end (lter
top)
Tapered
end (lter
top)
Hole
Hole
Spring
Fing
Filter
Spraying Troubleshoong - Cleaning the Inlet Filter
The lter at the boom of the sucon tube may also need cleaning. Check it every me you change spray
containers.
1. Remove the lter by unscrewing it from the sucon tube. Clean the lter with the appropriate cleaning solu-
on (warm, soapy water for latex materials, mineral spirits for oil-based materials).
2. Thread the lter back into place.
If aer compleng all of the steps in Spraying Troubleshoong you are sll experiencing problems spraying,
refer to the Troubleshoong secon.
Important Cleaning Notes - Read before cleanup
- When using latex materials, clean your sprayer and components with water. When using oil-based materials, use mineral spirits.
- Do not use mineral spirits on latex materials, or the mixture will turn into a jelly-like substance which is dicult to remove.
- No maer which cleaning soluon you use, make sure to dispose of it properly when nished cleaning your sprayer.
- Thorough cleaning and lubricaon of the sprayer is the most important step you can take to ensure proper operaon aer storage.
Warning! Follow these steps whenever cleaning with mineral spirits:
- Always ush spray gun at least one hose length away from spray pump.
• If collecng ushed solvents in one gallon metal container, place it into an empty ve gallon container, then ush.
• Area must be free from vapors.
5. Follow all cleanup instrucons.
• DO NOT use gasoline to clean your sprayer.
Cleanup-Latex materials
Follow these steps if you used latex materials AND if you have a garden hose available. If you do not have a garden hose available, follow the Cleanup for Oil-
Based Materials instrucons.