BorMann Pro BAP7000 - Latex Material Cleanup Procedure; Flushing the System with Water; Purging Material Back into Container

EN
WWW.BORMANNTOOLS.COM
12
6. Unclip the return tube from the sucon tube and place it into
the waste container. Turn the PRIME/SPRAY knob to PRIME.
10. When cleaning soluon comes from the spray gun, keep
holding the trigger and aim the spray gun into the side of the
waste container.
11. Trigger the gun unl the uid coming out of the gun is clear.
You may need to empty the waste container and connue ush-
ing.
12. Turn the PRIME/SPRAY knob to PRIME and trigger gun once
more to relieve pressure.
Spray into waste container
spray material into original container
Move on to Cleaning the Spray Gun Components.
9. While pulling the trigger, turn the PRIME/SPRAY
knob to SPRAY to purge material from the hose back
into the original container.
Keep holding trigger through next steps.
Keep holding trigger through next steps.
Hold trigger
Spray
Prime
Waste container
Containers should
be touching
Original
material
container
Hold trigger
7. Turn water supply on. Turn pump ON (l). Water will go
into the sucon tube and out through the return tube. Let
pump run for a few minutes to allow the return tube to be
ushed.
Leave pump running through steps 7 and 8
8. Place the original material container next to the waste con-
tainer. Aim the spray gun into the side of the original material
container and hold the trigger.