BorMann Pro BAP7000 - Oil-Based Material Cleanup; Flushing with Cleaning Solution; Solvent Handling Safety Precautions

EN
WWW.BORMANNTOOLS.COM
13
1. Lock the gun and remove spray p assembly. Submerge
sucon set into a bucket with appropriate cleaning soluon.
Bucket with cleaning soluon
Waste container
Containers should be
touching
Hold trigger
Original
material
container
2. Place a waste container next to the original material container.
Aim the spray gun into the side of the original material container
and hold the trigger.
3. While pulling the gun trigger, turn the pump ON (l), and turn
the PRIME/ SPRAY knob to SPRAY to purge material from the
hose back into the original container.
4. When cleaning soluon comes from the spray gun, keep holding
the trigger and aim the spray gun into the side of the waste
container (ground gun with a metal container if ushing with
ammable solvent).
5. Trigger the gun unl the uid coming out of the gun is clear. You
may need to dispose and obtain new cleaning soluon.
6. Turn the PRIME/SPRAY knob to PRIME and trigger gun once to
relieve pressure.
Spray cleaning soluon
into waste container
Spray material into original
container
Move on to Cleaning the Sucon Set.
Keep holding trigger through next steps.
- Hold trigger
- Turn pump ON(I)
- Turn PRIME/SPRAY knob to SPRAY
Hold trigger
Cleanup - Oil-based materials