BorMann Pro BAP7000 - Cleaning the Suction Set; Suction Set Component Cleaning; Pump Circulation for Cleaning

EN
WWW.BORMANNTOOLS.COM
14
Cleanup - Cleaning the Sucon Set
1. Lock the gun and turn the pump OFF (O). 2. Remove the sucon hose and return tube and
clean it using the appropriate cleaning soluon. You
should also wipe the threads of the inlet nut (a) and
remove and clean the soluon set inlet lter.
3. When sucon set is clean, thread the sucon tube
back into the inlet valve, and replace the return tube
onto the return tube ng. Replace clip.
5. Turn the PRIME/SPRAY knob to PRIME. Turn the pump
ON (l), and trigger the gun once into a waste container to
relieve pressure.
Note-If you used oil-based material, you
must ush the pump again using water to
prepare it for storage.
Move on to Cleaning the Spray Gun Com-
ponents
2 to 3 minutes
Let the pump circulate cleaning soluon through the
sucon set for 2-3 minutes. Turn the pump OFF.
4. Submerge the sucon set into a bucket of NEW
cleaning soluon.