BorMann Pro BAP7000 - Operating Instructions; Locking the Spray Gun Trigger; Plugging in the Sprayer; Power Connection Procedure

EN
WWW.BORMANNTOOLS.COM
6
Operang instrucons
This secon contains instrucons that will be repeated throughout this manual.
Locking the Spray Gun:
Always lock the trigger o when aaching the spray p or when the spray gun is not in use.
Spray Gun
The gun is locked when the trigger lock is at a 90º angle. (perpendicular to the trigger in
either direcon).
To lock the gun, turn the trigger lock forward
and slightly down unl it stops.
Plugging in the Sprayer
1. Check that the ON/OFF switch is in the OFF (O) posion.
ON/OFF switch
2. Plug the power cord into a grounded outlet or heavy duty
grounded extension cord. Plug in the extension cord. Refer to Im-
portant Electrical Informaon.
Pressure Relief Procedure
Be sure to follow the Pressure Relief Procedure when shung the unit o FOR ANY PURPOSE. This procedure is used to relieve pressure from the
spray hose.
1. Lock the spray gun o (see direcons above).
Flip the ON/OFF switch to the OFF posion.
2. Turn the PRIME/SPRAY knob to PRIME.
3. Unlock the spray gun and trigger
spray gun into the side of the material
bucket. Lock the spray gun.
ON/OFF switch