BorMann Pro BAP7000 - Effective Spraying Techniques; Achieving an Even Coating; Gun Angle and Distance Control; Proper Stroke Application

EN
WWW.BORMANNTOOLS.COM
9
The key to a good job is an even coang over the enre surface.
This is done by using even strokes. Follow the TIPS, below.
Tip:
Keep the spray gun at right angles to the surface.
This means moving your enre arm back and forth rather than just exing
your wrist.
Tip:
Keep the spray gun perpendicular
to the surface. Otherwise one end
of the paern will be thicker than
the other.
Tip:
Keep the spray gun perpendicular
to the surface. Otherwise one end
of the paern will be thicker than
the other.
Approximately
10 to 12 inches
Approximately
10 to 12 inches
Wrong way
Right way
Light coat
Incorrect Incorrect
Correct
Heavy coat Light coat
Tip: Trigger gun aer starng the stroke.Release the trigger before ending the stroke.The spray gun should be moving when the trigger is
pulled and released. Overlap each stroke by about 30%. This will ensure an even coang.
If you expect to be away from your sprayer for
more than one hour, follow the Short-Term Stor-
age instrucons
Start stroke Pull trigger Move
steadily
Release
trigger
End stroke
Keep stroke
even
Approximately 10
to 12 inches