BorMann PRO BPW4500 - Intended Use and Technical Data; Intended Use; Technical Data

EN
WWW.BORMANNTOOLS.COM
4
Intended use
Technical Data
not abuse extension cord and do not yank on any cord to disconnect. Keep cord away from heat and sharp edges. Always disconnect the extension cord from
the receptacle before disconnecng the machine from the extension cord.
WARNING: To reduce the risk of electrocuon, don’t start and run the machine in the rain or storm. Keep all connecons dry and o the ground. Do not touch
plug with wet hands. It is strictly prohibited to let water leak into the machine.
WARNING: When the machine is turned on, the interior pumps start and connue to run even if the pressure wand trigger has not been depressed. Running
the machine for more than 3 minutes without depressing the pressure wand trigger could cause heat damage to the motor and pumps, Please do not leave the
machine running unaended or unused for more than 3 minutes.
WARNING: When the machine is running, please maintain a constant water supply. Without water circulaon will damage the sealing rings of the machine.
WARNING: It is necessary to turn on the spray lance within one or two minutes aer the machine has been started. Otherwise, the temperature of the circu-
lang water within the machine will soon rise to a crical point, which will cause damage to the sealing rings inside the machine.
WARNING: Don’t start and run the machine in a place excessively cold so as to prevent the machine from the freezing current.
WARNING: This machine has been designed for only using cleaning water, do not use corrosive chemicals.
WARNING: Use cleaning agent recommend by the manufacturer.
WARNING: High-pressure jets can be dangerous if subject to misuse. The jet must not be directed at persons, animals, live electri-
cal equipment or the machine itself. Pressure washers should not be pointed at re walls, as it may be possible to damage them.
WARNING: Do not direct the jet against yourself or others in order to clean clothes or footwear.
WARNING: Disconnect from the electrical power supply before carrying out user maintenance.
If the mains cable is damaged it must be replaced by the manufacturer, or its service agent or similarly qualied person to avoid a hazard.
WARNING: Do not use the machine if a supply cord or important parts are damaged, e.g. safety devices, high pressure hoses, trigger gun.
WARNING: Be aware of the recoil caused by the water jet when the machine is switched on.
WARNING: When the machine is moving and installing, the machine must be in at. When moving the machine, pulling the handle to move it.
WARNING: Connect to the water supply. The machines are not suitable for connecon to portable water mains. Connect the machine to the water supply. (It
can be a water container).
Make sure the inlet water pressure keeps between 0.01MPa and 0.4MPa.The inlet pipe should at least 5 M long. Do not use the pipe if the pipe is damaged. If
you want connect this machine to portable water mains, you must install a backow preventer in the water pipe to prevent dirty water ow back to the drinking
water system. The backow preventer shall comply with EN 60335-2-79 ANNEX AA.
THE PORTABLE PRESSURE WASHING MACHINE is a highly specialized mulfunconal machine with exceponally reliable safety assurance, which may be used
to wash and clean cars, bikes and other outdoor equipment or garden paos, green houses etc.
Voltage/Frequency: 230-240V/50HZ
Type of motor: Inducon motor
Power: 2100W
Working pressure: 110bar
Max pressure: 165bar
Flow: 360L/Hour
Max Flow: 432L/Hour
Descripon of main parts (Picture A)
1. High pressure washer 5. Water inlet
2. On/o switch 6. Gun
3. Wheel 7. Hose Reel with Trigger Gun
Hose
4. Water outlet (backside) 8. Hose Reel Handle
* The manufacturer reserves the right to make minor changes to product design and technical specicaons with-
out prior noce unless these changes signicantly aect the performance and safety of the products. The parts
described / illustrated in the pages of the manual that you hold in your hands may also concern other models of
the manufacturer's product line with similar features and may not be included in the product you just acquired.
* Please note that our equipment has not been designed for use in commercial, trade or industrial applicaons.
Our warranty will be voided if the machine is used in commercial, trade or industrial businesses or for equivalent
purposes.
* To ensure the safety and reliability of the product and the warranty validity, all repair, inspecon, repair or re-
placement work, including maintenance and special adjustments, must only be carried out by technicians of the
authorized service department of the manufacturer.