BorMann PRO BPW4500 - Operating Instructions; Getting Started and Operation; Shut Down Procedures; Nozzle Adjustment and Maintenance

EN
WWW.BORMANNTOOLS.COM
5
Operang instrucons
Helpful Hints for Geng Started
Automac ON/OFF:
The motor on this pressure washer does not run connuously. It only
runs when the trigger of the spray gun is squeezed. Aer following the
start up procedures in this manual, turn the pressure washer ON and
squeeze the trigger for acvaon. See “Operang Instrucon” secon in
this manual for further details.
Bleeding the Gun:
It is very important to bleed the gun before using the pressure washer.
Squeeze the trigger to allow any air that is trapped inside of the unit and
hose to escape. Connue to squeeze trigger unl a steady stream of wa-
ter comes from the nozzle. (This process may take up to 2 minutes). See
“Operang Instrucons” secon for this process.
WARNING! This unit is to be connected to a cold water source ONLY.
WARNING! The motor of this pressure washer will NOT run. It will only operate when the trigger is squeezed.
- Connect the outlet hose to the washer and connect the spray gun to the outlet hose.
- Connect nozzle and nozzle extension.
- Check gauze lter is clear of any blockage.
- Connect the water supply hose.
- Check that the hose has no kinks in it.
- Turn on water and check for leaks.
- Depress trigger to allow air to be expelled though the pump and hoses, lock trigger.
- Plug in machine and turn on switch.
- Unlock trigger and use the pressure washer.
Shut down
1. Turn o the motor (push switch to the o posion).
2. Unplug the unit from the power source.
3. Turn o the water supply.
4. Press the trigger of the gun to depressurize the system.
5. Disconnect the garden hose from the pressure washer.
6. Wipe all surfaces of the unit with a damp clean cloth.
7. Engage the gun safety lock.
CAUTION: ALWAYS turn o the unit’s motor BEFORE turning o the unit’s water supply.
Serious damage could occur to the motor if the unit is run without water.
CAUTION: NEVER disconnect the high-pressure discharge hose from the machine while the system is sll pressurized. To depressurize the unit, turn o the
motor, turn o the water supply and squeeze the trigger 2-3 mes.
Adjustable spray nozzle
Turn o the spray lance rst, hold the rear part of spray nozzle, then
turn the front part of spray nozzle clockwise, Water may be sprayed
out from the spray nozzle in fan shapes (g 2); Turn the front part
of spray nozzle an-clockwise, Water may be sprayed out from the
spray nozzle linearly (g 1).
CAUTION: Water should be sprayed out from the spray nozzle in fan
shapes (g 2),when cleaning the car or other vehicle.
Fig. 1 Fig. 2
Fig. 3
Fig. 4
Water inlet screen
The water inlet lter must be inspected regularly, so as to avoid blockage and restricon in the water supply to the pump (g 3).
Hose-reel handle
The hose reel handle turns down for use and up for storage. To turn up the handle, pull out and turn up (g 4).