6
Foam cleaning method
Be sure to insert the cleaning soluon in the built-in sucon pot and remove the p as shown
in the gure.
Units with pao cleaner included
Click pao cleaner ① with lance extension ② rstly and then connect it ② with spray gun handle ③.
Note: All these ngs are bayonet ngs which push in then twist to lock.
Note: Prior to using the pao cleaner always check that you will not damage the surface area on an inconspicuous
test area rst.
* Not included with all models
Units with brushes included
The Electric Pressure Washer is supplied with a rotary brush and a xed brush. Both have so
bristles and can be used in conjuncon with the detergent dispenser to apply detergent to the
surface you are cleaning. These are ideal for cleaning car bodywork, windows etc. This is a low
pressure seng. The brushes connect to the lance extension. There is an adapter with each
brush; you must t it before connecng to the lance extension.
Note: Do not t brushes when the power is on.
Note: The brushes cannot be ed into the trigger gun and must be used in conjuncon with
the lance extension.
* Not included with all models
Gun safety device
Whenever you use the high pressure washer, we suggest you grip the in the right posion, with
one hand on the handle and the other on the lance, When you stop the machine it is necessary
to use the safety lock placed on the gun in order to avoid accidental.
Cleaning pin instrucon
• Using included p cleaner, or an unfolded paper clip, insert wire into the nozzle hole and
move back and forth unl debris is dislodged.
• Remove addional debris by back-ushing water through the nozzle. To do this, place end of
a garden hose ( with water running ) to the end of nozzle for 30-60 seconds.
Nozzle Tip Cleaner
To Next Page