What to do if BorMann Pressure Washer is leaking at gun/lance?
If your BorMann Pressure Washer is leaking at the gun or lance, it could be due to a worn sealing ring; consider replacing it. Another possibility is a loose hose connection, so tighten up the water joints.
Why is there no water pressure in my BorMann PRO BPW5300?
There could be several reasons for low or no pressure in your BorMann Pressure Washer. It might be due to the lance not being set in high pressure mode, so ensure it is correctly set. Check for leaks at the high-pressure connections and repair any found. Also, the nozzle may be obstructed, requiring cleaning. The water filter screen at the inlet could be clogged, so remove and clean it. An air lock in the hose or pump can also cause this issue; turn off the engine, ensure the water supply is on, squeeze the gun trigger to release trapped air, and restart the engine when a steady stream of water appears. The supply hose diameter might be too small, requiring a replacement with a larger bore hose. Finally, ensure you have an adequate water supply by checking the garden hose for kinks or bloc...
Crucial safety warnings for operating the pressure washer.
Understand equipment and user restrictions before operation.
Guidelines on PPE and safe operating procedures for user safety.
Specific safety measures for the gasoline engine component.
Specifications for water source, flow rate, and temperature.
Step-by-step guide for assembling the pressure washer.
Explanation of different nozzle types and their uses.
Instructions on how to operate the pressure washer.
Steps to safely shut down the pressure washer.
Instructions for cleaning a clogged nozzle.
Steps for cleaning the wand and lance.
Guidelines for transporting and storing the unit.
Specific instructions for storing the unit during winter.
Solutions for when the engine fails to start.
Solutions for issues with no or low pressure.
Solutions for water leaks at the gun or lance.
Important safety guidelines for operating the engine.
Procedures for inspecting and adding fuel to the engine.
Steps to check and maintain the engine oil level.
Detailed inspection procedures for various engine components.
Step-by-step guide to start the engine.
How to properly stop the engine.
Important safety considerations during engine operation.
Information regarding carburettor adjustment.
Regular inspection and tightening of bolts and nuts.
Checking for any fuel leaks.
Routine checks and cleaning of the air cleaner.
Schedule and procedure for changing engine oil.
Cleaning air inlets, cooling fins, and muffler area.
Checking and cleaning the ignition plug.
Procedures for inspecting and cleaning the fuel filter.
Service procedure for removing carbon deposits.
Guidelines for replacing the ignition plug.
Procedure for replacing the fuel pipe.
Detailed instructions for cleaning the air cleaner element.
Cleaning specific areas like muffler and cooling fins.
Detailed steps for spark plug inspection and maintenance.
Instructions for storing the unit for extended periods.
Conditions and limitations that void or exclude warranty coverage.
Detailed terms and conditions of the product warranty.
General| Power Source | Electric |
|---|---|
| Maximum Pressure | 150 bar |
| Voltage | 220-240 V |
| Max Pressure | 150 bar |
| Flow Rate | 530 l/h |
| Water Flow | 530 l/h |
| Engine | Electric Motor |
| Pump | Axial pump |
| Nozzles Included | 0°, 25°, 40° |
To Next Page