Maintenance and Cleaning
Nozzle cleaning
Wand/Lance
2. Disconnect the wand/lance from the gun.
removed.
5. Reconnect wand/lance to gun and turn on water supply.
Transporng and Storage
Storage
Winter Storage
Troubleshoong Guide
REMEDY
Engine will not start. 1. No fuel.
1. Lance not set in high pressure mode.
2. Leak at high pressure
6. Diameter of the supply hose too small.
2. Repair leak.
release all trapped air. When there is a
and restart the engine.
6. Replace hose with one of a larger bore
diameter.
-
es. Ensure water tap is fully open.
Water leaking at gun/lance 1. Worn sealing ring.
1. Replace sealing ring.
2. Tighten up water joints.
* The manufacturer reserves the right to make minor changes to product design and technical specifications without prior notice unless these changes significantly affect the performance and safety of the
products. The parts described / illustrated in the pages of the manual that you hold in your hands may also concern other models of the manufacturer's product line with similar features and may not be
included in the product you just acquired.
* To ensure the safety and reliability of the product and the warranty validity, all repair, inspection, repair or replacement work, including maintenance and special adjustments, must only be carried out by
technicians of the authorized service department of the manufacturer.
* Always use the product with the supplied equipment. Operation of the product with non-provided equipment may cause malfunctions or even serious injury or death. The manufacturer and the importer
shall not be liable for injuries and damages resulting from the use of non-conforming equipment.
EN
To Next Page