7
Equipping the shawlband
1. Equip the attached shawl band.
2. Turn on the engine, return the throttle lever to the
lowest speed position, and put the shawl band hook
to the hanging part of the machine.
3. Adjust the length of the shawl band so that the
blade may be parallel to the ground in the workîng
position. In order to prevent slack during operation,
turn up the extra part of the band from the buckle.
CUTTING OPERATION
Metal blade usage
left.
edge. Use that area for cutting shrubs, tough and
thick weeds. For cutting young grass. you can use
up to 2/3 from the tip of blade.
-
jects. Cut the young grass at middle speed, and eut
shrubs or tough and thick weeds at high speed.
IMPORTANT! Operating at low speed makes
it easier for grass, weeds, or twigs to become
caught up in the blades, and also it makes
the shaft and clutch wear down more quickly.
Nylon cutter usage
the engine rotation speed in operation should be
50% as large as when using metal blade.
-
tion. If you try to eut grass for the length of cord at
one time, rotation speed becomes lower due to re-
sistance and you cannot eut well. In case of large
resistance, get the nylon cutter away from grass
once, make the rotation speed higher, and eut a
small amount of grass at one time.
your clothes dirty.
MAINTENANCE
BLADE
-
tom corner is rounded.
grinder. It may cause cracks on blade.
AFTER 25 HOURS OF USE
Air cleaner
-
ter as required. Dry completely before installing. If the
element is broken or shrunk, replace with a new one.
-
crease fuel consumption while cutting down
the engine power. And operate the brush cut-
will quickly ruin the engine.
FUEL
WARING!
bringing any tlame or sparks near fuel.
area where fuel is handled or stored.
IMPORTANT
2-cycle engine. It can cause spark plug fouling, ex-
haust port blocking, or piston ring sticking.
-
riod of one month or more, may clog the carburetor
or resuit in the engine failing to operate properly. Put
remained fuel into an airtight container and keep it in
the dark and cool room.
-
cohol-free) and a quality-proven motor oil for air-cooled
2 cycle engines.
RECOMMENDED MIXING
RATIO GASOLINE 6
OPERATION
STARTING THE ENGINE
WARING!
-
ment is properly installed and securely fastened.
head clear of everything around it.
1 Turn the cap to the fuel tank to make sure that it is
2 Open the fuel tank cock.
3 Move the choke lever to the closed position.
When restarting immediately after stopping
the engine, move the choke lever to the open
position.
4 Set the throttle lever to the starting position
NOTE When restarting immediately after
stopping the engine, move the throttle lever
to the idling position.
rope quickly.
6. After the engine has started, open the choke gradu-
ally.
7. Allow the engine to run for 2 to 3 minutes to warm
up.
Stopping the engine
1. Return the throttle lever to the idling position.
2. Push the engine switch button.
To Next Page
Loading...