Bort BHR-2000M-Pro - High Pressure Cleaner Operation and Maintenance; Introduction; Technical Specifications; Product Components

9
ENGLISHGB
HIGH PRESSURE CLEANER
INTRODUCTION
The high pressure cleaner is quick and ecient for clean-
ing vehicles, machines, boats, buildings, etc., by the re-
moval of stubborn dirt using clean water and chemical
detergents.
When using chemical detergents, only use biodegradable
types. Only clean vehicle engines in areas in which suita-
ble oil traps are installed.
TECHNICAL SPECIFICATIONS (FIG. 1)
Power consumption 2 000 W
Max pressure 150 bar
Working pressure 120 bar
Maximum output
7,5 l/min /
450 l/min
Auto-sucking function +
Automatic blocking +
Hose 8 m
Power cord length 5 m
Voltage / Current
frequency
220 V / 50 Hz
Product weight 6,4 kg
PRODUCT ELEMENTS (FIG. 2)
1. Handle;
2. Adjust switch OFF/ON;
3. Power cord hook;
4. Power cord;
5. Water outlet;
6. Water inlet;
7. Trigger gun;
8. High-pressure hose holder;
9. High-pressure hose;
10. Trigger gun holder;
11. Spray wand holder;
12. Spray wand;
13. Detergent bottle;
14. Wheel;
15. Trigger gun protector.
THE COMPLETE SET INCLUDES:
• Adjustable spray nozzle;
• Pressure hose;
• Filter;
• Quick nozzles;
• Foam generator;
• Nozzle cleaning pin.
Product Life:
The service life of the product is 5 years.
Production date:
Is indicated on the packaging of the goods.
Shelf life:
Shelf life is not limited (subject to storage conditions).
Storage conditions:
Products are stored in dry, ventilated warehouses at tem-
peratures from 0 ° C to +40 ° C with a relative humidity of
not more than 80%.
Transportation:
It is strongly prohibited dropping and any mechanical im-
pact on the packaging during transportation.
When unloading / loading, it is not allowed to use any
type of equipment that works on the principle of packing
clamping.
SAFETY INSTRUCTIONS
When using electric machines always observe the safety
regulations applicable in your country to reduce the risk
of re, electric shock and personal injury. Read the fol-
lowing safety instructions and also the enclosed safety
instructions.
Keep these instructions in a safe place!
Electrical safety
Always check if your mains voltage corresponds with the
value on the type plate.
When replacing old cables or plugs: throw away old
cables or plugs immediately as soon as new ones have
replaced these. It is dangerous to put the plug of a loose
cable into the socket outlet.
When using extension cables:
Only use an approved extension cable that is suitable for
the machine’s power. The cores must have a diameter of
at least 1.5 mm2. When the extension cable is on a reel,
unroll the cable in its entirety.
All electrical connections e.g. extension cable, must be of
an approved waterproof type for outdoor use and marked
accordingly. Extension cables must be threecore, one of
which is EARTH.
Switch o the machine immediately in case of:
16. Malfunction in the mains plug, power cable or damag-
ing of cable.
17. Broken switch.
18. Smoke or stench of scorched insulation.
Specic safety rules
• Do not disconnect the plug by pulling on the electrical