9
16. High pressure hose reel.
THE COMPLETE SET INCLUDES:
• Adjustable spray nozzle;
• Pressure hose;
• Filter;
• Quick nozzles;
• Foam generator;
• Nozzle cleaning pin;
• Quick connector;
• Turbo nozzle.
Product Life:
The service life of the product is 5 years.
Production date:
Is indicated on the packaging of the goods.
Shelf life:
Shelf life is not limited (subject to storage conditions).
Storage conditions:
Products are stored in dry, ventilated warehouses at tem-
peratures from 0 ° C to +40 ° C with a relative humidity of
not more than 80%.
Transportation:
It is strongly prohibited dropping and any mechanical im-
pact on the packaging during transportation.
When unloading / loading, it is not allowed to use any
type of equipment that works on the principle of packing
clamping.
SAFETY INSTRUCTIONS
When using electric machines always observe the safety
regulations applicable in your country to reduce the risk
of re, electric shock and personal injury. Read the fol-
lowing safety instructions and also the enclosed safety
instructions.
Keep these instructions in a safe place!
Electrical safety
Always check if your mains voltage corresponds with the
value on the type plate.
When replacing old cables or plugs: throw away old
cables or plugs immediately as soon as new ones have
replaced these. It is dangerous to put the plug of a loose
cable into the socket outlet.
When using extension cables:
Only use an approved extension cable that is suitable for
the machine’s power. The cores must have a diameter of
at least 1.5 mm2. When the extension cable is on a reel,
unroll the cable in its entirety.
All electrical connections e.g. extension cable, must be of
an approved waterproof type for outdoor use and marked
accordingly. Extension cables must be threecore, one of
which is EARTH.
Switch o the machine immediately in case of:
17. Malfunction in the mains plug, power cable or damag-
ing of cable.
18. Broken switch.
19. Smoke or stench of scorched insulation.
Specic safety rules
• Do not disconnect the plug by pulling on the electrical
cable.
• If you are too far from the object you wish to clean, do
not move the cleaner nearer by pulling on the high pres-
sure hose; use the handle provided.
• Do not obstruct the ventilation grilles during operation.
• The cross-section of any extension cables used must be
proportional to their length, i.e. the longer the extension
cable, the greater the cross-section; cables with a protec-
tion level of “IPX5” must be used.
• Position the high pressure cleaner AS NEAR POSSIBLE to
the water supply.
• Use the high pressure cleaner only with accessories and
replacement parts authorized by the manufacturer. The
use of original accessories and replacement parts will en-
sure safe, trouble-free operation.
• Avoid unintentional ring of the trigger. Do not carry
the lance / trigger assembly with your hand over the trig-
ger. Always use the trigger lock mechanism.
• Ensure that the safety lock on the trigger is used, when
you have stopped using the pressure washer to prevent
accidental operation.
• Do not use the cleaner with inammable or toxic liquids,
or any products which are not compatible with the correct
operation of the high pressure cleaner.
• Do not direct the water jet towards the unit itself, electri-
cal parts or towards other electrical equipment.
• Do not allow children or incompetent persons to use
the high pressure cleaner.
• Do not touch the plug and/or socket with wet hands.
• Do not use the high pressure cleaner if the electrical ca-
ble is damaged.
• Do not use the high pressure cleaner if the high pressure
hose is damaged.
• Do not jam the trigger in the operating position.
• Check that the data plates are axed to the high pres-
sure cleaner, if not, inform your dealer. Cleaners without
plates must NOT be used as they are unidentiable and
potentially dangerous.
• Do not tamper with or alter the calibration of the safety
valve.
To Next Page
Loading...
Need help?
General
