14
Once mechanical and electrical connection is done according to chapter 5, the
LE300 will automatically start working and supporting the lead acid battery sys-
tem. Please push the pushbutton of LEs to check the status of the products (see
details in chapter 7).
It is recommended to fully charge the system once LEs were connected. A full
system charge is needed in order to give accurate information on the state of
charge of the system.
For devices which are stored over a longer period of time, several charging cycles
might be necessary. This is done to balance each lithium-cells and to show an
accurate state-of-charge-trend-display.
6. COMMISSIONING
Tighten the installed cables with a cable tie to the strain relief connectors to
avoid damages to the electronics from moving cables.
To Next Page
Loading...