To Next PageTo Next PageHow to fix no charging procedure possible for Bosch 0.600.881.K00 Lawn Mower?
If no charging procedure is possible for your Bosch Lawn Mower, consider the following: * Battery contacts: Clean the battery contacts by inserting and removing the battery several times or replace the battery. * Defective battery: The battery may be defective due to a disconnection in the individual cells. Replace the battery.
Why the charge control LEDs do not light up on my Bosch 0.600.881.K00?
If the charge control LEDs do not light up after inserting the mains plug into the socket for your Bosch Lawn Mower, check the following: * Mains plug: Ensure the mains plug of the battery charger is fully inserted into the socket outlet. * Defective components: The socket outlet, mains cable, or battery charger may be defective. Check the mains voltage and, if necessary, have the battery charger checked by an authorized customer service station for Bosch power tools.
What to do if my Bosch 0.600.881.K00 Lawn Mower functions intermittently?
If your Bosch Lawn Mower functions intermittently: * Internal wiring: The internal wiring of the lawn mower may be damaged. Contact a service agent. * Motor protector: The motor protector may have activated. Allow the motor to cool and increase the cutting height.
Why does my Bosch Lawn Mower have excessive vibrations or noise?
Excessive vibrations or noise in your Bosch Lawn Mower can be caused by: * Loose blade nut/bolt: Tighten the blade nut/bolt. * Damaged cutting blade: Replace the cutting blade.
Why does my Bosch 0.600.881.K00 Lawn Mower leave a ragged finish?
A ragged finish from your Bosch Lawn Mower, accompanied by motor labor, can be attributed to: * Cutting height: The height of cut may be too low. Increase it. * Blade condition: The cutting blade might be dull. Consider replacing the blade. * Clogging: Check underneath the lawn mower for any obstructions and clear them. Remember to wear gardening gloves. * Blade Installation: The blade might be fitted upside down. Refit it correctly.
What to do if the charge control LEDs of my Bosch 0.600.881.K00 Lawn Mower do not light up?
If the charge control LEDs do not light up after inserting the mains plug into the socket for your Bosch Lawn Mower, ensure the mains plug of the battery charger is fully inserted into the socket outlet. Also, check the mains voltage and have the battery charger checked by an authorized customer service station for Bosch power tools if necessary.
How to fix Bosch Lawn Mower when no charging procedure is possible?
If no charging procedure is possible for your Bosch Lawn Mower, it might be due to contaminated battery contacts. Try cleaning them by inserting and removing the battery several times. If this doesn't work, the battery may be defective and need replacement.
Why my Bosch 0.600.881.K00 Lawn Mower functions intermittently?
If your Bosch Lawn Mower functions intermittently, it could be that the motor protector has activated. Allow the motor to cool, and then increase the height of cut. If the issue persists, it may be due to internal wiring damage, in which case you should contact a service agent.
Why is there a delay in the motor starting on my Bosch Lawn Mower?
If you experience a short delay in the motor starting after engaging the switch lever on your Bosch Lawn Mower, hold the switch lever for 1 – 3 seconds to start the motor.
Why my Bosch Lawn Mower not working?
If your Bosch Lawn Mower fails to operate, several factors could be at play. First, check underneath the mower for any clogging and clear it out, wearing gardening gloves for protection. Ensure the battery is fully charged and properly inserted. If the grass is too long, increase the cutting height and tilt the mower to ease the starting load. The motor protector may have activated; allow the motor to cool and then increase the cutting height. Also, make sure the isolator key is correctly fitted and that the battery isn't too hot or cold. If the fuse in the isolator key is faulty, contact a service agent.
General| Power | 1200 W |
|---|---|
| Cutting width | 32 cm |
| Cutting height | 20-60 mm |
| Grass box capacity | 31 L |
| Voltage | 230 V |
| Frequency | 50 Hz |
| Weight | 6.8 kg |
