What to do if my Bosch ROTAK 37 LI motor starts and stops immediately?
If your Bosch Lawn Mower motor starts and stops immediately, several factors could be responsible: * Battery: Ensure the battery is fully charged and correctly inserted. Also, if the battery is too hot or cold, allow it to cool or warm down. * Isolator key: Verify that the isolator key is fully and correctly inserted. * Cutting height: Increase the height of cut.
Why does my Bosch ROTAK 37 LI fail to operate?
Your Bosch Lawn Mower might fail to operate due to several reasons: * Clogging: Check underneath the lawn mower and clear out any debris. Always wear gardening gloves. * Battery issues: Ensure the battery is fully charged and properly inserted. If the battery is too hot or cold, allow it to cool or warm. * Fuse: A faulty or blown fuse in the isolator key could be the problem. In this case, contact a service agent. * Grass length: If the grass is too long, increase the cutting height and tilt the lawn mower to reduce the starting load. * Motor protector: If the motor protector has activated, allow the motor to cool and increase the cutting height. * Isolator key: Make sure the isolator key is correctly and fully inserted.
What to do if my Bosch ROTAK 37 LI cutting blade is not rotating?
If the cutting blade of your Bosch Lawn Mower is not rotating while switched on: * Check for obstructions: Switch off the lawn mower and clear any obstructions. Always wear gardening gloves. * Blade nut/bolt: Ensure the blade nut/bolt is tightened.
Why isn't my Bosch Lawn Mower cutting area large enough on a single charge?
If your Bosch Lawn Mower isn't covering a large enough area on a single charge, consider these factors: * Cutting height: Increasing the height of cut. * Walking speed: Walk slower. * Grass conditions: Avoid cutting when the grass is wet or damp, and cut more frequently if the grass is dense.
How to fix no charging procedure possible for Bosch Lawn Mower?
If no charging procedure is possible for your Bosch Lawn Mower, consider the following: * Battery contacts: Clean the battery contacts by inserting and removing the battery several times or replace the battery. * Defective battery: The battery may be defective due to a disconnection in the individual cells. Replace the battery.
Why is there a delay in the motor starting on my Bosch ROTAK 37 LI Lawn Mower?
If you experience a short delay in the motor starting after engaging the switch lever on your Bosch Lawn Mower, hold the switch lever for 1 – 3 seconds to start the motor.
Why does my Bosch Lawn Mower leave a ragged finish?
A ragged finish from your Bosch Lawn Mower, accompanied by motor labor, can be attributed to: * Cutting height: The height of cut may be too low. Increase it. * Blade condition: The cutting blade might be dull. Consider replacing the blade. * Clogging: Check underneath the lawn mower for any obstructions and clear them. Remember to wear gardening gloves. * Blade Installation: The blade might be fitted upside down. Refit it correctly.
Why does my Bosch Lawn Mower have excessive vibrations or noise?
Excessive vibrations or noise in your Bosch Lawn Mower can be caused by: * Loose blade nut/bolt: Tighten the blade nut/bolt. * Damaged cutting blade: Replace the cutting blade.
What to do if my Bosch ROTAK 37 LI functions intermittently?
If your Bosch Lawn Mower functions intermittently: * Internal wiring: The internal wiring of the lawn mower may be damaged. Contact a service agent. * Motor protector: The motor protector may have activated. Allow the motor to cool and increase the cutting height.
General| Type | Push lawn mower |
|---|---|
| Cutting width | 370 mm |
| Cutting height | 20 - 70 mm |
| Cutting system | - |
| Recommended lawn area | 300 m² |
| Grass collecting volume | 40 L |
| Battery type | Li-Ion |
| Power source | Battery |
| Battery voltage | 36 V |
| Cordless | Yes |
Weight and Dimensions| Weight | 13000 g |
|---|
Provides essential safety guidelines and symbols for operating the lawnmower safely.
Offers specific precautions for mowing on slopes and uneven terrain.
Lists part numbers, dimensions, weight, battery type, voltage, and charger specifications.
Outlines the product's purpose and provides a general overview of the manual.
Lists included components and identifies key operational controls on the lawnmower.
Explains the charging process, LED status lights, and temperature monitoring during charging.
Details the rapid charging phase and how to interpret battery charge level indicators.
Covers battery charging outside optimal temperatures and error indications.
Step-by-step guide for assembling the handle and fitting/removing the battery pack.
Instructions for assembling and attaching the grass collection box.
Guidance on setting the lawnmower's cutting height for optimal performance.
Procedure for starting/stopping and advice for efficient mowing and battery life.
Explains the function of battery charge indicator LEDs and temperature monitoring.
Instructions for routine inspections, cleaning, and blade care.
Guidance on proper battery care, storage, and criteria for replacement.
Steps for cleaning the mower after use and preparing it for storage.
Lists optional accessories such as replacement blades for the lawnmower.
Addresses problems like machine not operating, starting issues, or intermittent function.
Resolves issues related to ragged finish, motor labouring, and short battery life.
Troubleshoots charging failures, excessive noise, and vibration issues.
Information on safe battery transport and environmentally friendly disposal guidelines.
Provides contact details for after-sales service and technical assistance.
Declares conformity with standards for noise, vibration, and safety for Rotak 37 LI.
Declares conformity with standards for noise, vibration, and safety for Rotak 43 LI.
To Next Page
