English 4
5. Place the right corner piece as shown (see Figure 3:
Right side corner cover placement). Align the round
hole in the corner cover with the hole at 1.
Figure 3: Right side corner cover placement
6. Insert screw (saved or from the kit) into hole 1 and
lightly tighten (see Figure 4: Screw placement).
Figure 4: Screw placement
7. Press up on the corner cover at the arrow (see Figure
5: Tighten screw) while finishing the tightening of the
screw.
Figure 5: Tighten screw
8. Repeat the previous steps 4 through 7 for the left side
corner cover.
9. If necessary, have a qualified service technician
reattach electrical connections.
10. To avoid scratching the countertop, check and, if
necessary, adjust the height of the range by adjusting
the range feet (see Figure 6: Adjusting range height).
Figure 6: Adjusting range height
11. Slide the range back into position. Be sure to engage
the anti-tip bracket. See the Tip Over Hazard Warning
earlier in this instruction and also in the Slide-In Range
Installation Manual.
To Next Page
Loading...
