English | 25
Bosch Power Tools 1 609 92A 1KX | (24.5.16)
After-sales Service and Application Service
Our after-sales service responds to your questions concern-
ing maintenance and repair of your product as well as spare
parts. Exploded views and information on spare parts can al-
so be found under:
www.bosch-pt.com
Bosch’s application service team will gladly answer questions
concerning our products and their accessories.
In all correspondence and spare parts orders, please always
include the 10-digit article number given on the nameplate of
the product.
Great Britain
Robert Bosch Ltd. (B.S.C.)
P.O. Box 98
Broadwater Park
North Orbital Road
Denham
Uxbridge
UB 9 5HJ
At www.bosch-pt.co.uk you can order spare parts or arrange
the collection of a product in need of servicing or repair.
Tel. Service: (0344) 7360109
E-Mail: boschservicecentre@bosch.com
Ireland
Origo Ltd.
Unit 23 Magna Drive
Magna Business Park
City West
Dublin 24
Tel. Service: (01) 4666700
Fax: (01) 4666888
Australia, New Zealand and Pacific Islands
Robert Bosch Australia Pty. Ltd.
Power Tools
Locked Bag 66
Clayton South VIC 3169
Customer Contact Center
Inside Australia:
Phone: (01300) 307044
Fax: (01300) 307045
Inside New Zealand:
Phone: (0800) 543353
Fax: (0800) 428570
Outside AU and NZ:
Phone: +61 3 95415555
www.bosch.com.au
Republic of South Africa
Customer service
Hotline: (011) 6519600
Spray jet pulsates
Not enough spray material in container Refill spray material
Suction tube 17 loose Slide the suction tube all the way onto the paint
channel 19
Container seal 16 not positioned or not cor-
rectly positioned in groove of suction tube 17
Mount the container seal 16 precisely all
around in the suction tube groove
Nozzle cap 10/11/12 loose Tighten the nozzle cap 10/11/12
Spray material dripping at the
nozzle cap
Deposit of spray material on the nozzle cap
10/11, the nozzle needle 15 and the air cap 2
Clean the nozzle cap, nozzle needle and air cap
Nozzle loose Tighten the nozzle cap 10/11/12
No spray material coming out of
the nozzle cap
Tool will not spray
Base unit is switched off Press the on/off button 25
No pressure build-up in container 7 because
container not completely closed
Turn the container 7 towards the close
symbol until you hear the lock ring 6 en-
gage
Suction tube 17 loose Slide the suction tube all the way onto the paint
channel 19
Nozzle cap 10/11/12 clogged Clean the nozzle cap
Suction tube 17 clogged Clean suction tube
Ventilation hole 18 on suction tube 17
clogged
Clean the suction tube and the ventilation hole
Container seal 16 missing or damaged Slide a (new) container seal over the suction
tube into the groove
Spray material too viscous Dilute the spray material again and carry out a
test-spray run
Spray material dirty (lumps of paint) Completely empty and clean the spray gun;
pour the spray material through the filling
sieve when filling
Problem Cause Corrective Measure
OBJ_BUCH-2026-005.book Page 25 Tuesday, May 24, 2016 1:38 PM
To Next Page
Loading...
