Bosch 120 Series - Product Description; Features

PI − 34.51 enProduktinformation FMC−120−DKM / ESTGLT
Page 4 of 18
BDL−F.01U.066.178
A2.en/ 11.04.2007
ST−FIR/ PRM1 / sib
1. Product description
The series 120 non−automatic fire detector is used for manual alarm triggering in conventional
line technology (GLT). The line is monitored according to the principle of voltage reduction and
increase.
The Form H detectors are designed for exterior areas, the Form G detectors for interior areas.
Overview of non−automatic fire detectors, series 120
Manual call points
D FMC−120−DKM−G−R Manual call point for interior areas (Form G), red
D FMC−120−DKM−H−R Manual call point for exterior areas (Form H), red
Manual call points
D FMC−120−DKM−G−B Manual call point for interior areas (Form G), blue
D FMC−120−DKM−H−B Manual call point for exterior areas (Form H), blue
D FMC−120−DKM−G−Y Manual call point for interior areas (Form G), yellow
Stop device
D FMC−120−EST−G−B Stop device for interior areas (Form G), blue
2. Features
D Manual call point and stop device: Trigger alarm by pushing the button. After alarm
triggering, the push button is adjusted.
D Detector query routines with evaluation and multiple transmission.
D Display (LED) for triggered alarms or inspection evaluation.
D Second contact with connections for panel control.
D Same design for interior use (Form G) and exterior use (Form H).
D Available in different colour variants; see order overview.
D For the red colour variants, a burning house" is applied to the detector housing in the
factory.
D Variable labelling is possible with foil sets for the blue and yellow colour variants.
D For exterior use in extreme environmental conditions, the detector is equipped with an
especially resistant PC board (parylene layering) and with a seal in the detector door.