21
Router Table Operation
CONNECTING THE ROUTER POWER CORD
TO THE SWITCH
Before connecting router to
router table switch box, ensure that
the router switch is OFF, and that the router table
switch box is unplugged. Such precautionary safety
measures reduce the risk of unintentional tool operation.
1. Plug the router power cord into one of the electrical
outlets on the back of the switch case (14).
2. Form the excess power cord into a coil.
3. Wrap two pieces of friction tape or strong cord around
the coiled cord at opposite sides of the coil.
4. Allow some slack so that the cord does not become
stretched when it is plugged into the switch box
outlets.
5. If desired, at this time plug the power cord from an
accessory, such as a wet/dry vac or light, into the
other outlet.
Before starting to work, ensure
that the power cords from the
router, accessories, the switch case, and the
extension cord do not and cannot come in contact
with the router or any moving parts of the router.
Such precautionary safety measures reduce the risk
of injury due to loss of control.
Cord Routing
Route the switch cord and any accessory power
cords through the notch in the vacuum port on
the back of the router table cabinet
.
VAC PORT ON
BACK OF TABLE
SWITCH AND
ACCESSORY
CORDS
To Next Page
Loading...
Need help?
General
