Bosch 2000 Series - Page 20

2000 Series | Program Entry Guide | 4.0 Receiver EN | 20
Bosch Security Systems | 7/05 | 35114F
10 Sys Res Group
Default:
0
Selection:
0 to 9, B to F
1 Successful connection to a remote
programmer.
2 Not used.
3 Control panel reset with the stand-by switch
(refer to the Installation Guide) or a remote
programmer.
4 Not used.
5 Not used.
6 Not used.
7 Reports missing or low battery restored.
8 Restored AC power.
9 Communication Restoral event for Phone 1.
B Communication Failure event for Phone 2.
C RF tamper restore (points or receiver).
D RF battery restore.
E RF receiver 7 restoral.
F RF receiver 8 restoral.
11 Duress Group
Default:
0
Selection:
0 to 9, B to F
1 to 3 Not used.
4 This report transmitted after six
attempts to enter an invalid passcode.
5 Duress passcode entered at keypad.
Refer to
Code 8 = Duress in Section
15.0 Passcodes.
7, 8 Not used.
12 Test Group
Default:
0
Selection:
0 to 9, B to F
1 to 5 Not used.
6 Service stop.
7 Service start.
8 Test Report.