Need help?Do you have a question about the Bosch AVENAR panel 2000 and is the answer not in the manual?
General| Brand | Bosch |
|---|---|
| Model | AVENAR panel 2000 |
| Category | Control Panel |
| Language | English |
Instructions on using the touch-sensitive display, including precautions.
Explanation of the meaning and status indicated by the different LEDs.
Instructions for powering the panel on/off and rebooting the system.
Steps for first-time setup including touch screen calibration and network settings.
Procedures for logging into and out of the panel controller.
Configuration of IP address, network settings, and Ethernet parameters.
Steps to establish a connection between the remote keypad and a panel.
Description of how alarm messages are presented on the panel.
Manual control of evacuation zones and associated functions.
Information on fire alarm verification and the 'time to investigate'.
Details on the alarm verification process and its conditions.
Steps to bypass detectors that have triggered an alarm.
How to access and view fault messages on the panel.
Information on how fault messages are displayed and managed.
Steps to block an element that has caused a fault.
Procedures for bypassing and un-bypassing individual elements.
Procedure for bypassing/un-bypassing the fault warning routing equipment output.
Steps to bypass the output to fault warning routing equipment.
Steps to un-bypass the output to fault warning routing equipment.
Procedures for blocking and unblocking individual elements.
How to display diagnostic information for elements within an LSN module.
How to display diagnostic information about specific modules.
Information and tests related to the panel's hardware.
Information and tools for managing network services.
Checking for inconsistencies between network settings.
Displaying parameters and status for the panel's Ethernet ports.
Overview of features for secure remote connections.
Options for organizing elements into groups for walktesting.
Steps for initiating and concluding a walktest.
Procedure for selecting elements and starting the walktest.
How to end the walktest for a specific walktest group.
Procedure to end the walktest for all groups and elements.
Methods for switching the panel between day and night operational modes.
Setting and changing the physical node address of the panel.
How to create and manage groups for elements.
How to adjust detector sensitivity settings on the panel.
Managing network settings like Ethernet and Remote Services.
Information on modifying and activating network settings via Ethernet.
Information and procedures for using the master password.
How to enter the permanent master password for full access.
Procedure to obtain and enter a temporary 24-hour master password.
Managing Remote Connect, Alert, and Maintenance services.
How to start, conduct, and end a fire drill simulation.
Procedures for resetting elements to their initial state.
To Next Page
